Fieldmann FZP 2020-E Bedienungsanleitung PDF herunterladen (Seite 14)

EN 14

FZP 2020-E

It is not necessary to push the chain saw into the cut. When the motor is running at full speed, push the chain

saw down lightly.

If the chain jams in the cut, do not attempt to free it by pulling, rather stretch open the cut using a wedge or

crowbar.

Safety brake (protection against kickback)

This chain saw is equipped with an automatic chain brake that, if it works correctly, immediately stops the

chain in the event of kickback. It is necessary to check the working order of the chain brake before every use

of the chain saw. Run the chainsaw at full speed for 1 - 2 seconds and then tilt the front protective cover. The

chain must stop immediately even when the motor is running at high speed. If the chain stops slowly or does

not stop at all, please contact an authorised service centre.

It is extremely important to check the working order of the chain brake and the sharpness of the chain before

every use to ensure that the necessary level of safety in the event of a kickback is maintained. Removing

safety accessories, incorrect maintenance or when using unsuitable guide bars or chains may, in the event

of kickback, result in serious injuries.

Cutting trees

Decide about the direction in which the tree will fall, respecting

the wind direction, incline angle of the tree and location of the

branches, and consider all other factors before cutting.

The area around the tree must be clear, without obstacles, and

must enable a stable stance. The escape route must be passable.

Cut a wedge into one third of the tree’s diameter on the side to

which the tree should fall. (see ﬁ g. Cutting trees, point 1)

From the opposite direction perform a separation cut at a level

above the wedge cut. (see ﬁ g. Cutting trees, point 2)

The tree will fall in the direction towards the wedge cut.

(see ﬁ g. Cutting trees, point 3)

ATTENTION!

When cutting trees, inform other people in the area about the potential danger. Cutting trees requires

experience and we do not recommend performing this task without the necessary experience.

Cutting logs

ATTENTION!

Always maintain a stable stance. Do not step on logs.

ATTENTION!

Before starting work, check that all components are in their place and that all nuts and bolts are tightened.

The log being cut may roll away. Especially when cutting on a slope, always stand above the log being cut.

Prevent kickback of the saw by following the instructions in chapter “Safety instructions”.

Before starting work, assess the direction of the force causing the cut trunk to bend. The ﬁ nal cut needs to

always be done from the opposite side of where the bending force is acting to prevent the guide bar from

being clamped inside the cut.

Only carry the chain saw with the motor turned off and the guide bar protected by the protective cover.

Cutting

Cutting trees

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare

Fieldmann FZP 2020-E Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motorsägen Fieldmann FZP 2020-E